And if it’s the kind of switch where the wires stab straight into the back, they’re hard to remove in any event. If that’s not noticed during installation, you could be setting the connection up for an arc fault, which can start a fire. Reattaching them might break the wires inside the wire nut. If the wires attach to the switch with screws, they’ve already been bent and fatigued. There are good reasons for cutting the wires rather than disconnecting them. Cut the existing wires as close to the switch as possible.Remove the screws holding the old switch in place and pull the device out of the box. Most dimmers, on the other hand, come with integral wire leads that connect to the house wires using wire nuts. One difference between dimmer switches and regular switches is that with the latter, the house wires attach directly to the switch. Sometimes more than one circuit feeds into the same box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |